Cino eC Pro - 10. Parameters (Cont.); 10.02. Latte Macchiato Selection

MAN1010119 rel. 01 dated 30.01.2014 page no. 40 of 52 page
www.rheavendors.com tel: 0039 02 966 551 fax: 0039 02 96 55 086 e mail: rheavendors@rheavendors.com
rheavendors group's sole property
cino eC PRO by
PROGRAMMING BUTTON N FUNCTIONING PROGR. TOTAL
COFFE WATER (200)
COFFE SEQUENCE
STEP DOWN BREWER
PRODUCT N (24)
START DELAY PRODUCT N (5)
BREAKS NUMBER
COFFEE TIME
TIME AFTER PREINFUS.
WATER N TIME (60)
START DELAY WATER N (0)
MIXER N (60)
START DELAY MIXER N (3)
MIXER SPEED N (LOW)
LATTE M START BREWER
PRODUCT LM (24)
START DELAY PRODUCT LM (200)
BREAKS NUMBER PROD LM
WATER LM TIME (60)
START DELAY WATER LM (150)
MIXER LM (80)
START DELAY MIXER LM (180)
MIXER LM SPEED (HIGH)
PRODUCT MILK LM
LM MILK WATER NUMBER
JUG
SELECTION NAME
parameters
prod n
water n
mixer n
prod LM
water LM
mixer LM
coffee water
selection
1st milk
1st delay
2nd milk
2nd delay
time
10.02. LM selection cino eC PRO can produce a drink called Latte Macchiato,
composed by milk and coffee and served in the cup in differently
coloured bands, typically milk, coffee and milk;
to get this special drink, refer to a specific package of instructions,
every step of which is called “LM dispensing cycle”;
le erogazioni di prodotto in sequenza sono:
- dispensing cycle of 1
st
mixed milk (at low speed rate);
10÷15 second pause;
- dispensing cycle of 2
nd
mixed milk (at high speed rate);
12÷20 second pause;
- dispensing cycle of espresso coffee;
the different milk consistency due to a different mixing treatment
enables coffee to remain in a central range, thus giving origin to
the “Latte Macchiato” drink;
act as follows in the programming menu:
flow diagram, “Latte Macchiato” selection;
the data supplied by the table provide for a “latte macchiato”
dispensing cycle and they can be adapted to achieve dispensing
cycles more suitable for the users’ wishes;
1° MILK
2° MILK
ESPRESSO
COFFEE