1660 Scanner —
Barcode Scanner
CipherLab dongle
Setup Cards
Quick Start Guide
a
a
a
a
1660/1661 Cordless
Scanner Quick Start Guide
1660 Scanner
1661 Scanner
requires two AAA Alkaline batteries.
requires own rechargeable Li-ion battery.
Remove battery cover and insert battery or batteries.
Press the key for about 2 seconds.
The scanner will respond with a long beep (high) tone, and the LED light will
become solid red and go off quickly.
Step 1:
Step 2: Power/Delete
Power/Delete Key
LED Indicator
Buzzer
Scan Window
Trigger Key
1661 only: Micro USB I/O Connector
Power on...
1661 Scanner —
Barcode Scanner
CipherLab dongle
Rechargeable Li-ion battery
Direct USB Cable
Setup Cards
Quick Start Guide
a
a
a
a
a
a
www.cipherlab.com
Open Your Box
>
Download the user manual CD contents using GoBetween, available at
.http://ccs.cipherlab.com
BT Connection —
CipherLab Dongle —
By factory default, the scanner is set to use BT HID for connecting to PC or target device.
You may change to BT SPP if necessary. BT pairing is required for establishing a connection.
You may use 3610 for a quick connection. All it takes is to scan the two barcode labels at
back of the dongle. No pairing is required. By factory default, the dongle is set to use USB
HID. You may change it to USB Virtual COM if necessary.
>>
By factory default, authentication is disabled on the scanner, meaning no PIN is required
unless a PIN code is displayed on the target device (see Random PIN).
Authentication
3610
Set Connection
Serial Number
While pairing, if you see a PIN code displayed on the target device, scan the ,
and barcodes to input the same code.
Start numeric
End
Use Random PIN
Preset PIN “0000” —
Preset PIN other than “0000” —
Scan the barcode. By factory default, it is set to use “0000”.
Scan the barcode.
Scan the , and barcodes.
Enable Authentication
Step 1: Enable Authentication
Step 2: Start numeric End
Use Preset PIN
Live Mode
>> See setup card: 3a/4a
>> See setup card: 2a/2b
If real-time data collection is not desired, you may set the scanner to work in Memory Mode.
Then, upload data when you are done with data collection.
Scan the barcode.
Any Live Mode connection will be suspended.
Scan data.
Scan the barcode. The scanner will resume Live Mode connection.
It will transmit data via preset BT interface or CipherLab dongle.
Scan the barcodes when you are done with data upload.
Step 1: Enable Memory Mode
Step 2:
Step 3: Send Data
Step 4: Clear Data & Confirm
>>>
If you’re using 1661, you may connect the USB cable for data upload, as well as for battery
charging. It takes about 4 hours to fully charge the battery.
Scan the barcode.
Scan data.
Connect the USB cable.
Scan the barcode when you are done with data collection.
Scan the barcodes when you are done with data upload.
Step 1: Enable Memory Mode
Step 2:
Step 3:
Step 4: Send Data
Step 5: Clear Data & Confirm
1661 Only
Memory Mode
>> See setup card: 1a
>> See setup card: 1a
Direct USB connection
for 1661 only
To Next Page
Need help?
General
