Need help?Do you have a question about the CipherLab 1661 and is the answer not in the manual?
General| Light Source | LED |
|---|---|
| Supported Barcode Types | 1D |
| Connectivity | RS-232, USB |
| Scan Rate | 100 scans/second |
| Scanning Range | 0 to 300 mm |
| Operating Temperature | 0°C to 50°C |
| Storage Temperature | -20°C to 60°C |
| Battery | Rechargeable Li-ion |
| Supported Symbologies | UPC/EAN, Code 39, Code 128, Interleaved 2 of 5 |
| Drop Specification | 1.5 m |
| Power Source | Battery |
| Type | Handheld Barcode Reader |
| Operating Humidity | 5% to 85% RH non-condensing |
| Humidity | 5% to 85% RH non-condensing |
FCC compliance information for devices in the USA, outlining limits for Class B digital devices.
Compliance with Canadian interference-causing equipment standards for Class B digital apparatus.
FCC compliance for RF functions in handheld products, including radiation exposure limits.
Initial steps to get acquainted with the scanner hardware and its components.
Step-by-step guide for installing batteries into the 1660/1661 scanners.
Instructions for charging the rechargeable battery of the 1661 model via USB.
Process for charging the scanner's battery using the provided external charger.
Steps to enter the scanner's setup mode using barcodes for configuration.
Procedures for saving settings and exiting the scanner configuration mode.
How to save current scanner settings as user defaults for later restoration.
Resetting scanner settings back to factory defaults using a setup barcode.
Instructions on how to read setup barcodes to configure scanner parameters.
Information about the scanner's battery types and power management features.
Overview and comparison of different scanner operational modes.
Setting the scanning time interval before the scan engine automatically times out.
Configuring the Bluetooth Human Interface Device profile for scanner output.
Setting up the scanner for Bluetooth Serial Port Profile (SPP) as a slave.
Configuring the scanner for Bluetooth Serial Port Profile (SPP) as a master.
Connecting via USB HID interface using the 3610 dongle for data transmission.
Procedure for establishing a wireless connection using the 3610 dongle.
Procedure for establishing a wireless connection via a Bluetooth dongle.
Detailed steps to connect the scanner to the 3610 dongle for communication.
Settings for enabling/disabling and configuring the Codabar barcode symbology.
Settings for enabling/disabling the Code 128 barcode symbology.
Settings for enabling/disabling EAN-13 barcode and its addons.
Configuring the case (normal, upper, lower) for transmitted alphabets.
Replacing specific characters in scanned data with others based on defined rules.
Setting prefix and suffix codes to be added before or after scanned data.
Defining criteria like applicable code type for data processing by editing formats.
Defining how scanned data is divided into fields based on start position and length.
Programming the order in which data fields and additional fields are transmitted.
Procedures for upgrading the firmware of 1660/1661 scanners via 3610 or USB.
Firmware upgrade process for 1661 scanners via Direct USB Virtual COM interface.
Firmware upgrade process for scanners via a Bluetooth dongle.
List of serial commands for controlling and configuring the 1660/1661 scanners.
Table listing serial commands for 3610 configuration and their purposes.
Information on key types and status settings applicable to HID interfaces.
Barcodes for entering decimal values used in scanner configuration.
Barcodes for entering hexadecimal values used in scanner configuration.
Using a preset PIN for authentication when configuring the scanner.
Disabling authentication or using a random PIN for scanner authentication.
To Next Page
