To Next Page

To Previous Page

215

Update

Appendix III

Keyboard Wedge Table

EXAMPLE

KEY TYPE = NORMAL

For example, if you want to program the character “!” as the prefix code:

1. Read the “Configure Prefix” barcode.

2. Read the “Hexadecimal Value” barcode on page 218 for “2” and “1”.

3. Read the “Validate” barcode to complete this setting.

KEY TYPE = SCAN CODE

For example, if you want to program the character “a” (= “1C” on the scan code table) as the

prefix code:

1. Read the “Configure Prefix” barcode.

2. Read the “Scan Code” barcode.

3. Read the “Hexadecimal Value” barcode on page 218 for “1” and “C”.

4. Read the “Validate” barcode to complete this setting.

KEY TYPE = NORMAL + KEY STATUS = SHIFT

For example, if you want to program the character “!” (= “Shift” + “1” on keyboard) as the prefix

code:

1. Read the “Configure Prefix” barcode.

2. Read the “Add Shift” barcode.

3. Read the “Hexadecimal Value” barcode on page 218 for “3” and “1”.

4. Read the “Validate” barcode to complete this setting.

KEY TYPE = NORMAL + KEY STATUS = CTRL

For example, if you want to program “Ctrl+A” and “Ctrl+$” as the prefix code:

1. Read the “Configure Prefix” barcode.

2. Read the “Add Left Ctrl” barcode.

3. Read the “

Hexadecimal Value” barcode on page 218 for “4”, “1” (= “A”).

4. Read the “Add Left Ctrl” barcode.

5. Read the “Hexadecimal Value” barcode on page 218 for “2”, “4” (= “$”).

6. Read the “Validate” barcode to complete this setting.

CipherLab 1661 User Manual

Other manuals for CipherLab 1661