34
Enter Setup
1660 Barcode Scanner
User Guide
1.4.3 LOW BATTERY ALARM (1660)
By default, “2.6 V (Alkaline)” is selected for low battery level. When the battery level
inside the 1660 scanner reaches 2.6 V, it will activate the beeper to give a warning. If
you are using Ni-MH batteries, select “2.1 V (Ni-MH)”. In order to prevent data loss, you
are advised to replace the batteries immediately when you hear two short beeps (high
tone).
No Alarm
*2.6 V (Alkaline)
2.1 V (Ni-MH)
Note: Ni-MH batteries available in retail stores can be used to replace the two AAA
Alkaline batteries.
1.4.4 LOW BATTERY ALARM (1661)
By default, it will activate the beeper to give a warning when the battery charge gets low.
In order to prevent data loss, you are advised to replace the battery immediately when
you hear two short beeps (high tone).
No Alarm
*Low Battery Alarm
To Next Page
Loading...
Need help?
General
