Circontrol Raption Series - So, Hello; Important Safety Instructions

02
So, hello!
Important safety instructions
• Do not use the Charge Point for
anything other than electric ve-
hicle charging modes which are
defined in IEC 61851-1.
• Do not modify the Charge Point. If
modified, CIRCONTROL will reject
all responsibility and the warran-
ty will be void.
• Comply strictly with electrical
safety regulations according to
your country.
• Do not make repairs or manipula-
tions with the unit energised.
• Only trained and qualified per-
sonnel should have access to the
electrical parts inside the Charge
Point.
• Check the installation annually by
qualified technician.
• Remove from service any item
that has a fault that could be dan-
gerous for users (broken connec-
tors, caps that don’t close...).
• Use only Circontrol supplied
spare parts.
• Do not use this product if the en-
closure or the EV connector is
broken, cracked, open, or shows
any other indication of damage.
• Adaptors or conversion adapters
and cord extensions set are NOT
allowed to be used.
• The device does not emit noise, ul-
trasounds, electromagnetic fields
and does not produce harmful
substances, thanks to which it can
be operated in the environment.
• Pay attention to traffic in busy
streets.
• Waste generated after the disas-
sembly of a waste device or a de-
vice taken out of service is hand-
ed over to a person conducting
activity in the field of recycling or
conducting activity in the field of
recovery processes.