20
Bonding:
A lug used for bonding is attached to the bottom of the Universal
Series Control Module. The Control Module must be bonded with an 8
AWG copper wire to the pool bonding system.
Electrolytic Cell and Flow Switch Connections:
The Cell and Flow Switch cables have easy plug-in connectors, which
attach easily to the Control Module. Refer to the diagram below for the
location of these connections.
Wiring to Power Source:
Always double-check the voltage of your power source. Connection to
improper voltage can: a) cause severe damage/harm, or b) cause lights
and screen to power on without system function.
The RJ-Series is shipped from the factory with a 240 VAC configuration.
If 120VAC is needed, move the internal jumpers as shown on page 23. If
unsure, seek professional advice.
To Next Page
Loading...
