Information Manual 7-87
Cirrus Design Section 7
SR22 Airplane Description
• Generate and display a moving map based on GPS position
data with obstacle and terrain data.
• Display Stormscope lightning strike bearing and distance.
• Display Skywatch traffic advisory information. (EX5000C
only)
• Display a GPS flight plan based on pilot inputs.
• Display Normal and Emergency checklists as well as
performance data.
• Display navigation data, such as groundspeed and track.
The pilot can configure the moving map display. Some of its
configuration features are:
• Select Track-up or North-up modes.
• Select map scale.
• Select terrain features, such as airports and special use
airspace and select color enhanced terrain.
• Select and view trip data from GPS.
Power for the MCU is 28 VDC supplied through the 5-amp MFD circuit
breaker on the Avionics Non-Essential Bus.
• Note •
Serials 0002 through 1103 before MFD software version 530-
00162-000 Revision 02; Do not use the Garmin 420 or 430
Navigators to display Stormscope lightning data when the
Avidyne MFD’s Lightning mode is set to either DATALINK or
OFF. For the Garmin 420 or 430 Navigators to accurately
display lightning strikes, the Lightning mode selected on the
MFD’s MAP Page, must be set to either STRIKE or CELL.
Refer to Avidyne FlightMax EX5000C Pilot’s Guide, for a more
complete description of the MFD, its operating modes, and additional
detailed operating procedures.
March 2010
To Next Page