CIRRUS DESIGN SR22 - Pre-Flight Walk-Around; Before Takeoff

P/N 13772-127 7 of 14
Cirrus Design Section 9
SR22 Supplements
Section 4 - Normal Procedures
Preflight Walk-Around
1. System Vents.............................................................Unobstructed
2. System Drains............................................................Unobstructed
Ground Operation
• Note •
To facilitate faster cabin cooling, prior to engine start leave the
cabin doors open for a short time to allow hot air to escape
cabin.
For maximum cabin cooling, set Airflow Selector to fan speed
3, Vent Selector to feet/panel/defrost position, and
Temperature Selector to recirculation mode. Additionally,
ensure the instrument panel and armrest eyeball outlets are
open. (See Figure - 1)
1. Control Panel .................SELECT Desired Mode and Temperature
2. Voltage........................................................................... MONITOR
• Note •
Decrease electrical load if battery discharge is noted.
3. Annunciator Lights ............................................................. CHECK
a. Verify ALT 1 caution light out and positive amps indication.
4. Engine Parameters ............................................................ CHECK
Before Takeoff
1. Air-conditioner..........................................................................OFF
Revision 01: 03-27-07