CIRRUS DESIGN SR22 - Page 91

Information Manual 4-7
Cirrus Design Section 4
SR22 Normal Procedures
d. COM 2 Antenna (underside) ...........Condition and Attachment
e. Baggage Door ........................................... Closed and Secure
f. Static Button.............................................. Check for Blockage
g. Parachute Cover........................................ Sealed and Secure
3. Empennage
a. Tiedown Rope .............................................................Remove
b. Horizontal and Vertical Stabilizers.............................Condition
• Note •
Verify tape covering the forward and aft inspection holes
located on outboard ends of horizontal stabilizer is installed
and securely attached.
c. Elevator and Tab............................... Condition and Movement
d. Rudder.................................................. Freedom of Movement
e. Rudder Trim Tab...................................Condition and Security
f. Attachment hinges, bolts and cotter pins ......................Secure
4. Right Fuselage
a. Static Button.............................................. Check for Blockage
b. Wing/Fuselage Fairings..................................................Check
c. Door Lock...................................................................... Unlock
5. Right Wing Trailing Edge
a. Flap and Rub Strips (if installed) ..........Condition and Security
b. Aileron and Tab ................................ Condition and Movement
c. Aileron Gap Seal .........................................................Security
d. Hinges, actuation arm, bolts, and cotter pins ................Secure
6. Right Wing Tip
a. Tip ..........................................................................Attachment
b. Strobe, Nav Light and Lens..................Condition and Security
c. Fuel Vent (underside) ..........................................Unobstructed
(Continued on following page)
March 2010