Rev Z Page 20 11/28/2011
Copyright © 2011 by Cirus Controls, LLC. All Rights Reserved. No part of this material may be reproduced without the express
written permission of Cirus Controls LLC for each reproduction.
Change the Prescription from off to Rx1 and hit pass to enter values for prescription RX1:
In this example, the prescription has been set as follows:
Temperature Range (F) Salt Spread Rate
Above 35 degrees 200 (lbs/mile)
34-32 degrees 300 (lbs/mile)
31-29 degrees 350 (lbs/mile)
28-25 degrees 400 (lbs/mile)
Below 25 degrees 500 (lbs/mile)
(Note: these rates are for illustration only and are not process recommendations).
Select “blast” and return to the Granular material screen to confirm prescription is set:
Your prescription for your granular material named “salt” is now set. To set another granular
material, choose name #2-10, select Prescription RX2-4 and repeat the process.
When operating the SpreadSmart Rx or RDS, the letters Rx is added to the display to show that
Temp Response ™ is controlling the granular and pre-wet spreading rate.
For Pre-Wet or Anti-Ice prescription setting, choose one of those “materials” and begin the
naming and prescription setting process as above. Because the distribution rate varies with
material, a prescription must be set individually for each.
To Next Page
Loading...
Need help?
General