Cisco MERAKI MS250 Series User Manual

Off
No link is detected on this
port
3
Redundant Power
Supplies
Green
Active and functional
power supplies
Power input Power cords may be ordered separately.
Equipment is to be used only in a restricted access location and installed/operated only by trained service personnel.
Bringing your Stack Online
MS250 switches can be connected in a physical stack using dedicated stacking ports and cables. Configuration steps
and additional information about stacking can be found here.
Mounting hardware
The mounting hardware includes a rack mount kit for standard 1U racks. When installing the device, make sure that
there is sufficient space between the rear of the rack and other obstacles to ensure adequate airflow.
Optional Mid-Mount bracket
All MS250 models are designed for an optional MA-MNT-MID-1 mid-mount bracket when using 2-post racks.
4

Cisco MERAKI MS250 Series Specifications

General

Model	MS250 Series
Series	MS250
Form Factor	Rack-mountable
DRAM	2 GB
Flash Memory	4 GB
Input Voltage	100 - 240 VAC
Operating Temperature	0°C to 40°C
Humidity	5% to 95% non-condensing
Ports	24 or 48 Gigabit Ethernet
Uplink Interfaces	4 x 10G SFP+
Switching Capacity	176 Gbps
Forwarding Rate	130.95 Mpps
Power Supply	Internal
Stacking	Yes
Layer	Layer 2 and Layer 3
Product Type	Switch
PoE	PoE+
PoE Budget	740W
Management	Cloud-managed
Storage Temperature	-20°C to 60°C
Warranty	Lifetime hardware warranty