Cisco 1700 Hardware Installation Guide

Statement 1090—Installation by Skilled Person
Only a skilled person should be allowed to install, replace, or service this equipment. See statement 1089
for the definition of a skilled person.
There are no serviceable parts inside. To avoid risk of electric shock, do not open.
Warning
Statement 1091—Installation by an Instructed Person
Only an instructed person or skilled person should be allowed to install, replace, or service this equipment.
See statement 1089 for the definition of an instructed or skilled person.
There are no serviceable parts inside. To avoid risk of electric shock, do not open.
Warning
Step 1 Remove the drive that you are replacing:
a) Press the release button on the face of the drive tray.
b) Grasp and open the ejector handle and then pull the drive tray out of the slot.
Figure 34: Remove the Drive
Release button2Ejector handle1
Step 2 Remove the four drive-tray screws that secure the drive to the tray and then lift the drive out of the tray.
Cisco Secure Firewall Management Center 1700, 2700, and 4700 Hardware Installation Guide
37
Installation, Maintenance, and Upgrade
Remove and Replace a Drive

Cisco 1700 Specifications

General

Form Factor	Desktop
WAN Slots	1
VPN Support	Yes
Connectivity Technology	Wired
Flash Memory (max)	16 MB
Flash Memory	8 MB
Routing Protocols	BGP, EIGRP, OSPF
Product Type	Router
Data Link Protocol	Ethernet, Fast Ethernet
Remote Management Protocol	SNMP, Telnet
Features	Firewall, VPN, NAT, DHCP
Supported Protocols	BGP, EIGRP, OSPF
Security Features	Firewall
Humidity	10%