Cisco 1941W User Manual

119
Cisco 3900 Series, Cisco 2900 Series, and Cisco 1900 Series Integrated Services Routers Generation 2 Software Configuration Guide
Chapter Configuring Backup Data Lines and Remote Management
Configuring Data Line Backup and Remote Management Through the ISDN S/T Port
Step 7
interface dialer dialer-rotary-group-number
Example:
Router(config)# interface dialer 0
Router(config-if)#
Creates a dialer interface (numbered 0 to 255) and
enters interface configuration mode.
Step 8
ip address negotiated
Example:
Router(config-if)# ip address negotiated
Router(config-if)#
Specifies that the IP address for the interface is
obtained through PPP/IPCP (IP Control Protocol)
address negotiation. The IP address is obtained
from the peer.
Step 9
encapsulation encapsulation-type
Example:
Router(config-if)# encapsulation ppp
Router(config-if)#
Sets the encapsulation type for the interface.
Step 10
dialer pool number
Example:
Router(config-if)# dialer pool 1
Router(config-if)#
Specifies the dialer pool to be used.
In the example, the dialer pool 1 setting associates
the dialer 0 interface with the BRI0 interface
because the BRI0 dialer pool-member value is 1.
Step 11
dialer string dial-string# [:isdn-subaddress]
Example:
Router(config-if)# dialer string 384040
Router(config-if)#
Specifies the telephone number to be dialed.
Step 12
dialer-group group-number
Example:
Router(config-if)# dialer group 1
Router(config-if)#
Assigns the dialer interface to a dialer group
(1–10).
Step 13
exit
Example:
Router(config-if)# exit
Router(config)#
Exits dialer interface configuration mode and
enters global configuration mode.
Step 14
dialer-list dialer-group protocol protocol-name
{permit | deny | list access-list-number |
access-group}
Example:
Router(config)# dialer-list 1 protocol ip
permit
Router(config)#
Creates a dialer list for packets of interest to be
forwarded through the specified interface dialer
group.
In the example, dialer-list 1 corresponds to
dialer-group 1.
For details about this command and additional
parameters that can be set, see Cisco IOS Dial
Technologies Command Reference.
Command Purpose

Cisco 1941W Specifications

General

Brand	Cisco
Model	1941W
Category	Network Router
Language	English