Need help?Do you have a question about the Cisco ASR 1001-X and is the answer not in the manual?
General| Product color | Gray |
|---|---|
| Rack capacity | 1U |
| Rack mounting | Yes |
| Networking standards | - |
| Ethernet LAN (RJ-45) ports | 6 |
| Installed SFP modules quantity | 2 |
| Flash memory | 1024 MB |
| Internal memory | 8192 MB |
| Processor cores | 4 |
| AC input voltage | 85 - 264 V |
| Power source type | AC |
| Power consumption (typical) | 250 W |
| Storage temperature (T-T) | -40 - 70 °C |
| Operating temperature (T-T) | 0 - 50 °C |
| Storage relative humidity (H-H) | 5 - 95 % |
| Operating relative humidity (H-H) | 5 - 90 % |
| Security algorithms | AES |
Weight and Dimensions| Depth | 461.5 mm |
|---|---|
| Width | 439.42 mm |
| Height | 43.43 mm |
| Weight | 10590 g |
Details the hardware capabilities and specifications of the Cisco ASR 1001-X Router.
Lists the various hardware components supported by the Cisco ASR 1001-X Router.
Provides specifications and details for the AC and DC power supplies.
Outlines the essential steps and requirements before beginning the site installation.
Provides essential safety guidelines to prevent injury and equipment damage during installation.
Provides guidelines for electrical wiring and power requirements for the router.
Specifies the dedicated electrical circuit requirements for powering the router.
Explains procedures and guidelines to prevent damage from electrostatic discharge (ESD).
Covers essential electrical safety precautions when working with the router.
Step-by-step instructions for powering on the Cisco ASR 1001-X Router for the first time.
Guides through the initial configuration process using the setup command facility or CLI.
Provides procedures for upgrading the ROMMON on the Cisco ASR 1001-X Router.
Procedures for removing and installing AC and DC power supplies for the router.
Step-by-step guide to safely remove AC power supply modules from the router.
Step-by-step guide to safely install AC power supply modules into the router.
Procedures for safely removing DC power supplies from the router.
Instructions for installing DC input power leads to the router's DC power supply.
Procedures for removing and replacing DIMM memory modules in the router.
Step-by-step guide for removing Shared Port Adapters (SPAs) from the router.
Instructions for removing Network Interface Modules (NIMs) from the Cisco ASR 1001-X Router.
To Next Page
