Cisco ASR 1001-X User Manual

Cisco ASR 1001-XCharacteristic
17.3 in. (439.42 mm)Width
22.50 in. (571.5 mm) Depth includes
cable-management brackets; card and power-supply
handles for mounting in a 600 mm enclosed cabinet.
Depth
25 lb (11.35 kg) fully loadedWeight
The following list describes additional Cisco ASR 1001-X Router characteristics:
•
Chassis height meets EIA-310 rack spacing 1RU (1.71 in. or 43.43 mm), universal rack mount
•
Chassis width meets EIA-310 19 in. (17.3 in. or 439.42 mm) wide with rack brackets
•
Cable-management brackets allow a bend radius of 1.5 in. (38.1 mm) for cables
•
Ships with forward rack-mount brackets installed and an extra set included in the accessory kit
Site Power Guidelines
The Cisco ASR 1001-X Router has specific power and electrical wiring requirements. Adhering to these
requirements ensures reliable operation of the system. Follow these precautions and recommendations when
planning your site for the Cisco ASR 1001-X Router:
•
The redundant power option provides a second, identical power supply to ensure that power to the chassis
continues uninterrupted if one power supply fails or input power on one line fails.
•
In systems configured with the redundant power option, connect each of the two power supplies to a
separate input power source. If you fail to do this, your system might be susceptible to total power failure
due to a fault in the external wiring or a tripped circuit breaker.
•
To prevent a loss of input power, be sure the total maximum load on each circuit supplying the power
supplies is within the current ratings of the wiring and breakers.
•
Check the power at your site before installation, and periodically after installation, to ensure that you
are receiving clean power. Install a power conditioner if necessary.
•
Provide proper grounding to avoid personal injury and damage to the equipment due to lightning striking
power lines or due to power surges. The chassis ground must be attached to a central office or other
interior ground system.
This product requires short-circuit (overcurrent) protection to be provided as part of the building installation.
Install only in accordance with national and local wiring regulations.
Caution
Cisco ASR 1001-X Router Hardware Installation Guide
33
Preparing Your Site for Installation
Site Power Guidelines

Cisco ASR 1001-X Specifications

General

Product color	Gray
Rack capacity	1U
Rack mounting	Yes
Networking standards	-
Ethernet LAN (RJ-45) ports	6
Installed SFP modules quantity	2
Flash memory	1024 MB
Internal memory	8192 MB
Processor cores	4
AC input voltage	85 - 264 V
Power source type	AC
Power consumption (typical)	250 W
Storage temperature (T-T)	-40 - 70 °C
Operating temperature (T-T)	0 - 50 °C
Storage relative humidity (H-H)	5 - 95 %
Operating relative humidity (H-H)	5 - 90 %
Security algorithms	AES

Weight and Dimensions

Depth	461.5 mm
Width	439.42 mm
Height	43.43 mm
Weight	10590 g