Cisco ASR 1001-X - Cisco ASR 1001-X Overall Chassis Front View

•
Stratum 3E network clocking per GR-1244-CORE, using 1588, 10 GE, GE, SPA, or Network Interface
Module (NIM) interfaces as timing sources.
•
Six built-in 1 GE SFP-only interfaces (do not support SFP+), and two built-in 10 GE SFP+ interfaces
(support only 10-GE rate) that support SyncE.
•
One half-height SPA bay.
•
Software redundancy using Dual IOS, similar to all the other nonhardware redundant routers from the
Cisco ASR 1000 Series Aggregation Services Router family.
•
LED indicators for Ethernet and console status, as well as visual system state indications.
•
Command-line interface (CLI), alarm, network management, logging, statistics aggregation, and on-board
failure logging (OBFL).
•
Environmental chassis management.
•
10 MB ternary content-addressable memory (TCAM).
•
Up to 20 Gbps sustained forwarding data traffic through the chassis.
•
One Network Interface Module (NIM) bay.
The NIM bay supports the T1/E1 NIMs and the Solid State Device (SSD) NIM assembly and drive.Note
•
Field-replaceable units (FRU) with online insertion and removal (OIR).
Cisco ASR 1001-X Overall Chassis Front View
The following figure shows the front of the Cisco ASR 1001-X Router.
Figure 1: Cisco ASR 1001-X Router Front View
Shared port adapter slot7NIM slots1
USB port 08
CON—One mini eUSB
por
2
USB port 19
PWR—Power LED
3
Cisco ASR 1001-X Router Hardware Installation Guide
2
Cisco ASR 1001-X Router Overview
Cisco ASR 1001-X Overall Chassis Front View