Cisco ASR 1001-X - Removing and Replacing FRUs from the Cisco ASR 1001-X Router; Removing and Replacing the Cisco ASR 1001-X Router Power Supplies

CHAPTER 7
Removing and Replacing FRUs from the Cisco
ASR 1001-X Router
This chapter describes procedures for removing and replacing field-replaceable units (FRUs) from Cisco
ASR 1001-X Routers.
This chapter contains the following sections:
•
Removing and Replacing the Cisco ASR 1001-X Router Power Supplies, page 91
•
Removing and Replacing Cisco ASR 1001-X Router USB Flash Memory Stick or Secure Token, page
101
•
Removing and Replacing the Cisco ASR 1001-X Router DIMM, page 102
•
Removing and Replacing a Cisco ASR 1001-X Router SPA , page 108
•
Removing and Replacing a NIM on the Cisco ASR 1001-X Router, page 111
•
Removing and Replacing an SSD from the NIM-SSD Module, page 113
•
Repacking the Router, page 118
Removing and Replacing the Cisco ASR 1001-X Router Power
Supplies
The following sections describes the procedures for removing and replacing the Cisco ASR 1001-X Router
power supplies.
The Cisco ASR 1001-X Router has redundant power supplies that can be hot-swapped.Note
The covers are an integral part of the safety design of the product. Do not operate the unit without the
covers installed. Statement 1077
Danger
Cisco ASR 1001-X Router Hardware Installation Guide
91