What to do if my Cisco Network Router fails to power on?
If your Cisco Network Router fails to power on, ensure that all power cords are correctly connected both to the router and at the power connection end. Also, verify that the power switch is in the ON position.
What to do if Cisco ASR 1002-X system fails to boot up properly?
If your Cisco Network Router has power but fails to boot up properly, check the STATUS LED on the ASR 1000 Series route processor. Make sure all connections are secure.
General| Form Factor | Rack-mountable |
|---|---|
| Rack Units | 2RU |
| Integrated Services | Yes |
| Maximum Memory | 16 GB |
| Built-in Gigabit Ethernet Ports | 6 |
| Input Voltage | 100-240 VAC |
| Operating Temperature | 32 to 104°F (0 to 40°C) |
| Redundancy | Power supply redundancy |
| Network Interface Modules | Up to 4 SPA/SIP slots |
| Embedded Services Processor (ESP) | ESP-20 |
| Maximum Packet per Second (PPS) | 15 Mpps |
| Height | 3.5 inches |
| Fixed Ports | 6 GE ports |
| Memory | 4 GB (default), 16 GB (maximum) |
| Power Supply | Dual power supplies (AC or DC) |
| Dimensions (H x W x D) | 3.5 x 17.5 x 19.0 in (8.9 x 44.5 x 48.3 cm) |
History of document changes and versions.
Forum for suggesting improvements to Cisco documentation.
Information on acquiring Cisco documentation and requesting support.
Guidelines for preparing the installation site and unpacking the router.
Verification steps before shelf or tabletop router installation.
Decisions and preparations before rack-mounting the router.
Steps to attach front-mounted rack-mount brackets to the router chassis.
Procedure for installing the router in a two-post equipment rack.
Instructions for mounting cable-management brackets to the router.
Procedure for connecting the router chassis to earth ground.
How to connect cables to the console and auxiliary ports.
Procedure to connect the router's management Ethernet port.
Information on connecting cables for shared port adapters.
Routing network interface cables using cable-management brackets.
Instructions for connecting AC and DC power supplies to the router.
Steps to power on and boot the router after installation.
Steps to access the Command Line Interface via the console port.
Configuring system-wide parameters using the setup facility.
Verifying current router configuration settings.
Storing configuration changes to NVRAM.
Steps to upgrade the router's traffic throughput level.
Information on advanced configuration and reference guides.
Procedure for safely shutting down and powering off the router.
Instructions for removing and installing ESP modules.
Steps for removing and installing shared port adapters (SPAs).
Procedures for removing and replacing power supply units.
To Next Page
