To Next PageTo Next Page
Need help?Do you have a question about the Cisco ASR1002 - ASR 1002 Router and is the answer not in the manual?
General| Form Factor | Rack-mountable |
|---|---|
| Maximum Throughput | 10 Gbps |
| Operating System | Cisco IOS XE |
| Product Type | Router |
| Product Series | ASR 1000 |
| Model | ASR1002 |
| Encryption Throughput | Up to 2.5 Gbps |
| Memory | 4 GB DRAM |
| Power Supply | AC or DC |
| Interfaces | 4 x SFP |
| Redundancy | Power supply (optional) |
| Input Voltage | 100-240 VAC |
| Modular Slots | 2 x SPA slots |
| Rack Unit Height | 2U |
Guidance on preparing the chassis for mounting within a rack.
Steps to attach front rack-mount brackets to the router chassis.
Steps to attach rear rack-mount brackets to the router chassis.
Instructions for installing the chassis in a four-post equipment rack.
Instructions for installing the chassis in a two-post equipment rack.
How to connect console and auxiliary ports using RJ-45 cables.
Steps for connecting the management Ethernet interface.
References to connecting cables for shared port adapters.
Instructions for routing and securing cables with brackets.
Instructions for connecting AC power to the router.
Instructions for connecting DC power to the router.
Procedures to check if power supplies are functioning correctly.
Steps to power on and initialize the router system.
Steps to access the Command Line Interface via the console port.
Guide to setting up global system parameters via the setup script.
Instructions to save current router configuration to non-volatile memory.
Guidance on advanced configuration topics and related publications.
Procedure to safely shut down and power off the router.
Instructions for removing and installing SPAs.
Steps to safely remove an AC power supply unit from the chassis.
Steps to safely remove a DC power supply unit from the chassis.
Instructions for installing a DC power supply unit into the chassis.
