To Next PageTo Next Page
Need help?Do you have a question about the Cisco ASR 9000 and is the answer not in the manual?
General| Operating System | Cisco IOS XR |
|---|---|
| Management | CLI, SNMP, NETCONF, RESTCONF |
| Type | Edge Router |
| Interface Support | 10G, 40G, 100G, 400G |
| Power Supply | AC and DC options available |
| Routing Protocol | BGP, IS-IS, OSPF, EIGRP |
| Storage | SSD |
| Operating Temperature | 0 to 40°C (32 to 104°F) |
| Humidity | 5 to 95% (noncondensing) |
| Redundancy | Yes (Power, Fabric, Route Processor) |
| MTBF | Varies by model (typically > 200, 000 hours) |
Explains the initial router configuration process upon booting.
Guides on selecting and identifying the active RSP/DSC for router operation.
Provides steps for connecting to the router using the console port for initial setup.
Guides on connecting and configuring username/password for a standalone router.
Provides procedures to verify the router's status after the initial boot.
Explains how to establish communication with the router via CLI.
Details the process of logging into the router using username and password.
Details the two-stage process for making and committing configuration changes.
Explains how to manage committed configuration changes and perform rollbacks.
Explains how to use show commands to display system status and configuration.
Introduces basic commands for diagnosing connectivity and router operation.
Explains how to display and interpret configuration error messages.
Covers low-memory warnings and how to resolve them.
Provides steps to verify and troubleshoot interface status issues.
