Cisco ASR 9000 - Creating Configuration Templates

125
Cisco ASR 9000 Series Aggregation Services Router Getting Started Guide
OL-28417-02
Chapter CLI Tips, Techniques, and Shortcuts
Wildcards, Templates, and Aliases
crc 32
!
keepalive disable
--More--
The following example shows how the state of all interfaces is displayed:
RP/0//CPU0:router# show interfaces * brief
Intf Intf LineP Encap MTU BW
Name State State Type (byte) (Kbps)
--------------------------------------------------------------------------------
/1/0/0 up up HDLC 4474 2488320
/1/0/1 up up HDLC 4474 2488320
/1/0/2 up up HDLC 4474 2488320
/1/0/3 up up HDLC 4474 2488320
/1/0/4 up up HDLC 4474 2488320
/1/0/5 up up HDLC 4474 2488320
/1/0/6 up up HDLC 4474 2488320
/1/0/7 up up HDLC 4474 2488320
/1/0/8 up up HDLC 4474 2488320
/1/0/9 up up HDLC 4474 2488320
/1/0/10 up up HDLC 4474 2488320
/1/0/11 up up HDLC 4474 2488320
/1/0/12 up up HDLC 4474 2488320
/1/0/13 up up HDLC 4474 2488320
/1/0/14 up up HDLC 4474 2488320
/1/0/15 up up HDLC 4474 2488320
Creating Configuration Templates
Configuration templates allow you to create a name that represents a group of configuration commands.
After a template is defined, it can be applied to interfaces by you or other users. As networks scale to
large numbers of nodes and ports, the ability to configure multiple ports quickly using templates can
greatly reduce the time it takes to configure interfaces.
The two primary steps in working with templates are creating templates and applying templates. The
following procedure describes how to create a configuration template.
SUMMARY STEPS
1. configure
2. template template-name [($parameter $parameter...)] [config-commands]
3. Enter the template commands.
4. end-template
5. commit
6. show running-config template template-name