Cisco ASR 9000 User Manual

69
Cisco ASR 9000 Series Aggregation Services Router Getting Started Guide
OL-28417-02
Chapter Configuring General Router Features
Manually Setting the Router Clock
Output 5 broadcast packets, 0 multicast packets
0 output errors, 0 underruns, 0 applique, 0 resets
0 output buffer failures, 0 output buffers swapped out
1 carrier transitions
Related Documents
Manually Setting the Router Clock
Generally, if the system is synchronized by a valid outside timing mechanism, such as a Network Time
Protocol (NTP) or VINES clock source, you do not need to set the software clock. Use the clock set
command for initial configuration or if a network time source is not available.
The clock timezone command should be entered before the clock is set because it defines the difference
between the system time and Coordinated Universal Time (UTC). When you set the time, you set the
system time, and the router uses the clock timezone command setting to translate that time to UTC. The
system internally keeps time in UTC. When you enter the show clock command, the router displays the
system time.
To manually set the router clock, follow these steps:
SUMMARY STEPS
1. configure
2. clock timezone zone hours-offset
3. commit
4. end
5. clock set hh:mm:ss dd mm yyyy
6. clock update-calendar
7. show clock
Related Topic Document Title
Additional information about configuring management
interfaces
Cisco Interface and Hardware Component Configuration
Guide

Cisco ASR 9000 Specifications

General

Brand	Cisco
Model	ASR 9000
Category	Network Router
Language	English