Cisco ASR 1001-X - Configuring the Console Idle Privileged EXEC Timeout

PurposeCommand or Action
Returns to privileged EXEC mode.end
Example:
Router(config)# end
Step 4
Enables privileged EXEC mode.enable
Step 5
Example:
Router> enable
Verify that your new enable or enable secret password works.
(Optional) Returns to privileged EXEC mode.end
Example:
Router(config)# end
Step 6
Configuring the Console Idle Privileged EXEC Timeout
This section describes how to configure the console line’s idle privileged EXEC timeout. By default, the
privileged EXEC command interpreter waits 10 minutes to detect user input before timing out.
When you configure the console line, you can also set communication parameters, specify autobaud connections,
and configure terminal operating parameters for the terminal that you are using. For more information on
configuring the console line, see the Cisco IOS Configuration Fundamentals and Network Management
Configuration Guide . In particular, see the “Configuring Operating Characteristics for Terminals” and
“Troubleshooting and Fault Management” chapters.
SUMMARY STEPS
1.
enable
2.
configure terminal
3.
line console 0
4.
exec-timeout minutes [seconds]
5.
end
6.
show running-config
DETAILED STEPS
PurposeCommand or Action
Enables privileged EXEC mode.enable
Step 1
Cisco ASR 1001-X Router Hardware Installation Guide
57
Cisco ASR 1001-X Router Power Up and Initial Configuration
Using the Cisco IOS-XE CLI--Manual Configuration