Cisco ASR 1001-X User Manual

The power supply has a handle to be used for insertion and extraction. The module must be supported with
one hand because of its length. The following figure shows the Cisco ASR 1001-X Router DC power supply.
Figure 8: Cisco ASR 1001-X Router DC Power Supply
DC power connector3Handle1
Retaining latchFAIL and OK LEDs2
AC/DC Power System Input Range and Voltage for the Cisco ASR 1001-X Router
The power supply DC Input Range is –40 to –72 VDC, and the AC Input Range is +85 to +264 VAC. The
following table describes the Cisco ASR 1001-X Router power supply LEDs.
Table 8: Cisco ASR 1001-X Router — AC and DC Power Supply LEDs
DescriptionLED Color and State
Input power is on and within the normal operating
range. On the AC unit, the LED is solid green when
the system in powered on. When the system is
powered off, the LED will blink until the AC power
is removed.
OK - (Solid green)
Input power that is within the normal operating range
is being supplied, but the Standby switch is in the
Standby position (and not in the On position).
OK - (Blinking Green at the rate of one blink per
second)
Power output has failed.Fail - (Red)
Cisco ASR 1001-X Router Hardware Installation Guide
19
Cisco ASR 1001-X Router Supported Hardware Components
AC/DC Power System Input Range and Voltage for the Cisco ASR 1001-X Router

Cisco ASR 1001-X Specifications

General

Product color	Gray
Rack capacity	1U
Rack mounting	Yes
Networking standards	-
Ethernet LAN (RJ-45) ports	6
Installed SFP modules quantity	2
Flash memory	1024 MB
Internal memory	8192 MB
Processor cores	4
AC input voltage	85 - 264 V
Power source type	AC
Power consumption (typical)	250 W
Storage temperature (T-T)	-40 - 70 °C
Operating temperature (T-T)	0 - 50 °C
Storage relative humidity (H-H)	5 - 95 %
Operating relative humidity (H-H)	5 - 90 %
Security algorithms	AES

Weight and Dimensions

Depth	461.5 mm
Width	439.42 mm
Height	43.43 mm
Weight	10590 g