Cisco 2500 Series Getting Started Guide

6
Cisco 2500 Series Wireless Controller Getting Started Guide
About This Guide
Caution Do not connect a Power over Ethernet (PoE) cable to the console port. Doing so will damage the
controller.
Note Wait at least 20 seconds before reconnecting an access point to the controller. Otherwise, the controller
may fail to detect the device.
Note Precautions for the direct AP connection: Do not configure interfaces on the physical ports, if AP is
connected to the port. If an interface is configured on the port where AP is connected, the behavior is
undefined. If the physical ports are configured, remove it and reload the controller.
ALM Alarm LED The alarm LED determines a status or error occurred.
The status or error is posted on the console screen.
LED description:
• Blinking Green—Controller image upgrading.
• Amber—Controller status activity, such as firmware
upgrade.
• Blinking Amber—Controller error. For example, a
temperature error exists.
Callout Port and LEDs State and Description

Cisco 2500 Series Specifications

General

Brand	Cisco
Model	2500 Series
Category	Controller
Language	English