4-10 Cisco 2500 Series Access Server User Guide
Configuring the Access Server
cisco Systems, Inc.
170 West Tasman Drive
San Jose, California 95134-1706
Cisco Internetwork Operating System Software
IOS (tm) 3000 Software (IGS-C-L), Version 11.0(0.8), SOFTWARE
Copyright (c) 1986-1995 by cisco Systems, Inc.
Compiled Mon 19-Jun-95 23:22 by
Image text-base: 0x030200E4, data-base: 0x00001000
cisco 2500 (68030) processor (revision C) with 16380K/2048K bytes of
memory.
Processor board ID 2685538369
SuperLAT software copyright 1990 by Meridian Technology Corp).
TN3270 Emulation software (copyright 1994 by TGV Inc).
X.25 software, Version 2.0, NET2, BFE and GOSIP compliant.
Bridging software.
Authorized for Enterprise software set. (0x0)
1 Ethernet/IEEE 802.3 interface.
2 Serial network interfaces.
8 terminal lines.
32K bytes of non-volatile configuration memory.
4096K bytes of processor board System flash (Read ONLY)
Notice: NVRAM invalid, possibly due to write erase.
--- System Configuration Dialog ---
At any point you may enter a question mark '?' for help.
Refer to the 'Getting Started' Guide for additional help.
Use ctrl-c to abort configuration dialog at any prompt.
Default settings are in square brackets '[]'.
Step 3 Enter yes or press Return when you are asked if you would like to enter the
configuration dialog and if you would like to see the current interface summary.
Press Return to accept the default (yes):
Would you like to enter the initial configuration dialog? [yes]:
First, would you like to see the current interface summary? [yes]:
Any interface listed with OK? value "NO" does not have a valid
configuration
To Next Page
Loading...
Need help?
General
