Installing and Removing Cards 78-5294-02 10/02/98
6 Cisco 6200 FRU Installation and Replacement
Step 9 In addition to saving the configuration to the startup configuration, you may want to copy
it to a PCMCIA Flash memory card. The following command copies the startup
configuration to a file named “6200-config” on the PCMCIA card in slot 0.
c6200# copy startup-config slot0:6200-config
1.1.3 Additional Steps for MPC Replacement
If you are replacing an MPC, follow these steps after you complete the steps in the “Card
Installation” section on page 3. This procedure does not interrupt the flow of data.
Note In this procedure, it is assumed that you have prepared a backup PCMCIA Flash card, as
described in the Cisco 6200 User Guide in Chapter 6, “Preventive Maintenance.” The backup
PCMCIA card should contain the Cisco IOS software image and the current configuration file for
the system. The backup PCMCIA card should be moved from the old MPC to the new MPC before
the new MPC is installed in the chassis.
Step 1 At the console, look for this prompt and answer No:
Would you like to enter the initial configuration dialog? [yes]: no
Step 2 At the Router> or c6200> prompt, enter enable and the password to access privileged
EXEC mode:
C6200> enable
Password:
c6200#
Step 3 Enter the dir command to display the names of the files on the PCMCIA card in slot 0:
6200# dir slot0:
-#- -length- -----date/time------ name
1 1166308 Jul 06 1998 14:33:55 c6200-dcm-mz.113-1.DA1.bin
2 1121 Jul 06 1998 14:44:30 6200-config
19410616 bytes available (1167688 bytes used)
Step 4 Enter the copy command to copy the configuration file from the PCMCIA card to
running-config in memory:
6200# copy slot0:6200-config running-config
6200#
%SYS-5-CONFIG: Configured from slot0:6200-config by console #
Step 5 Enter another copy command to copy the configuration file from the PCMCIA card to
startup-config in NVRAM:
6200# copy slot0:6200-config startup-config
Building configuration...
To Next Page
Loading...
Need help?
General
