Chapter 1 Cisco 7200 VXR Product Overview
Field-Replaceable Units
1-50
Cisco 7200 VXR Installation and Configuration Guide
78-5469-03
Figure 1-22 C7200-I/O-FE-MII LEDs and CPU Reset Button
Port Adapters and Service Adapters
The port adapters and service adapters installed in the Cisco 7200 VXR routers
are of the same type as those installed on the second-generation Versatile
Interface Processors (VIPs) in the Cisco 7500 series routers, in Cisco 7000 series
Table 1-19 C7200-I/O-FE-MII I/O Controller LEDs
LED Color Function
FE ENABLE Green Indicates that the Fast Ethernet port is initialized and enabled for operation
by the system. This LED comes on after the I/O controller has been enabled
and remains on during normal operation of the router.
This LED is disabled by the system software when the I/O controller with
the Fast Ethernet port is installed in a Cisco 7202.
FE LINK Green Indicates that the Fast Ethernet port has established a valid link with the
network. This LED remains off during normal operation of the router
unless there is an incoming carrier signal.
This LED is disabled by the system software when the I/O controller with
the Fast Ethernet port is installed in a Cisco 7202.
H6523
FE
ENABLE
SLOT 1
SLOT 0
FE LINK
CPU RESET
IO POWER OK
FAST ETHERNET INPUT/OUTPUT CONTROLLER
ENABLED
ENABLED
To Next Page
Loading...
