1-61
Cisco 7200 VXR Installation and Configuration Guide
78-5469-03
Chapter 1 Cisco 7200 VXR Product Overview
Functional Overview
In the following example, most of the status information for each interface is
omitted.
Router# show interfaces
FastEthernet0/0 is administratively up, line protocol is up
Hardware is DEC21140, address is 0000.0000.0000 (bia 0000.0000.0000)
Internet address is 1.1.1.3
MTU 1500 bytes, BW 100000 Kbit, DLY 100 usec, rely 255/255, load 1/255
(display text omitted)
Ethernet1/0 is administratively down, line protocol is down
Hardware is MIF68840_MM, address is 0000.0000.0000 (bia
0000.0000.0000)
Internet address is 1.1.1.0
MTU 4470 bytes, BW 100000 Kbit, DLY 100 usec, rely 255/255, load 1/255
(display text omitted)
Serial2/0 is administratively up, line protocol is up
Hardware is AmdP2, address is 0000.0000.0000 (bia 0000.0000.0000)
Internet address is 1.1.1.7
MTU 1500 bytes, BW 100000 Kbit, DLY 1000 usec, rely 255/255, load
1/255
(display text omitted)
You can also use arguments such as the interface type (Ethernet, Token Ring,
ATM, and so forth) and the port address (slot-number/port-number) to display
information about a specific interface only.
The following example shows the display for the first port on the Fast Ethernet
port adapter in port adapter slot 3:
Router# show interface fastethernet 3/0
FastEthernet3/0 is up, line protocol is up
Hardware is DEC21140, address is 0000.0000.0000 (bia 0000.0000.0000)
Internet address is 1.1.1.8
MTU 1500 bytes, BW 100000 Kbit, DLY 100 usec, rely 255/255, load
1/255
Encapsulation ARPA, loopback not set, keepalive not set
Full-duplex, 100Mb/s, 100BaseTX/FX
ARP type: ARPA, ARP Timeout 04:00:00
(display text omitted)
To Next Page
Loading...
