1-17
Cisco 7200 Series Port Adapter Hardware Configuration Guidelines
OL-3875-11
Chapter 1 Cisco 7200 Series Port Adapter Installation Requirements
Bandwidth and Bandwidth Point Requirements
1-port Fast Ethernet I/O
controller (MII connector)
C7200-I/O-FE-MII
10
High 200 0.10 MB —
No Ethernet port I/O controller C7200-I/O None 0 — —
Fiber Distributed Data Interface (FDDI)
Multimode PA-F-MM
11
High 100
11
0.10 MB —
Single-mode PA-F-SM
11
100
11
Full-duplex multimode FDDI PA-F/FD-MM
11
200
11
Full-duplex single-mode FDDI PA-F/FD-SM
11
200
11
High Speed Serial
1-port high-speed serial PA-H (Rev. B) High 100 0.10 MB —
2-port high-speed serial PA-2H (Rev. B) 200
Multichannel Serial
1-port channelized T3 dual-width PA-CT3/4T1
11
High 0
11
0.80 MB —
2-port channelized E1/Primary
Rate Interface (PRI) ISDN
PA-2CE1/PRI-75
11
Low 0
11
1.80 MB 1.20 MB (when
configured for
ISDN)
PA-2CE1/PRI-120
11
2-port channelized T1/PRI ISDN PA-2CT1/PRI
11
Low
3
0 1.80 MB 1.20 MB (when
configured for
ISDN)
8-port multichannel T1/E1 PRI PA-MC-8TE1+ Low
3
010 MB
1-port multichannel E3 PA-MC-E3 High 90 3.00 MB With 2
interfaces
configured for
PPP
encapsulation
6.40 MB With 128
interfaces
configured for
PPP
encapsulation
1-port multichannel E1 STM1 PA-MC-STM-1SMI High 250 10 MB —
1-port multichannel E1 STM1 PA-MC-STM-1MM High 250 10 MB —
Table 1-6 Bandwidth, Bandwidth Points, and Processor Memory Requirements (continued)
Port Adapter Type Product Number
Bandwidth
Resource
Requirement
Bandwidth
Points
Processor
Memory
Required
1
Additional
Requirements