Cisco 7500 Series - Page 291

Index
IN-7
Cisco 7500 Series Installation and Configuration Guide
OL-5008-03 B0
modifications 4-19
notes 5-1, 6-1, 7-1
register
bit meanings
4-5 to 4-7, A-1
boot field 4-5, A-2
boot filename 4-6, A-3
broadcast address settings 4-6, A-4
changing settings 4-7
configuration 4-4 to 4-7
displaying the configuration register while running
Cisco IOS
A-5
displaying the configuration register while running
ROM monitor
A-5
setting the configuration register while running Cisco
IOS
A-6
setting the configuration register while running ROM
monitor
A-6
transmission rate settings 4-7
sample 4-13 to 4-15, 4-16 to 4-17
configuration procedures, basic 4-1 to 4-20
configure terminal command 4-7
configuring
AppleTalk
4-14
global parameters 4-12
procedure 4-13
sample configuration 4-14 to 4-15
interface parameters
examples of
4-15, 4-16
sample configuration 4-16 to 4-17
IPX 4-14
the Cisco 7500 series routers 4-11 to 4-19
using AutoInstall 4-11
using configuration mode 4-18
using setup command facility 4-12
confreg command 4-9
connecting
auxiliary port
3-32
console port 3-32
DC-input power
Cisco 7505
3-9
Cisco 7507 and Cisco 7507-MX 3-16
Cisco 7513, Cisco 7513-MX, and Cisco 7576 3-29
console port
connecting devices to
3-32
description 1-44
pinout 1-44
settings 4-7
terminal 8-6, 8-14
cooling subsystem 8-3, 8-17
copy command, (Flash memory) 4-29
copy running-config startup-config command 4-12, 4-19
copy tftp flash command 4-27
CPU
halt LED on RSP2
8-21
halt LED on RSP4 and RSP8 8-22
system
RSP2
1-32
RSP4 1-35
critical status level, environmental monitor
Cisco 7505
2-24
Cisco 7507 and Cisco 7507-MX 2-25
Cisco 7513, Cisco 7513-MX, and Cisco 7576 2-25
CSA agency approvals
Cisco 7505
1-6
Cisco 7507 1-10
Cisco 7507-MX 1-14
Cisco 7513 1-19
Cisco 7513-MX 1-24
Cisco 7576 1-30
current rating, AC and DC 1-19, 1-24, 1-30
customer service, accessing 4-32
CxBus description 1-2
CyBus
arbiter clock generation
1-50
arbitration 1-50
Cisco 7505 1-4
Cisco 7507 1-8
Cisco 7507-MX 1-12
Cisco 7513 1-18