Cisco 800 Series Configuring

Configuring Radio Settings on an Access Point
How to Configure Radio Settings on an Access Point
7
4. power local {cck | ofdm} {milliwatt | maximum}
or
power local {milliwatt | maximum}
5. power client {milliwatt | maximum}
6. end
7. copy running-config startup-config
DETAILED STEPS
Command or Action Purpose
Step 1
enable
Example:
Router> enable
Enables privileged EXEC mode.
• Enter your password if prompted.
Step 2
configure terminal
Example:
Router# configure terminal
Enters global configuration mode.
Step 3
interface dot11Radio interface
Example:
Router(config)# interface dot11Radio 0/3/0
Enters radio interface configuration mode.
• The interface argument is in module/slot/port format,
except for the Cisco 800 series and Cisco 1800 series
fixed-configuration routers, where the interface
argument is either 0 or 1.
• The 2.4-GHz radio is port 0, and the 5-GHz radio is
port 1.
Step 4
power local {cck | ofdm} {milliwatt | maximum}
or
power local {milliwatt | maximum}
Example:
Router(config-if)# power local 20
(Optional) Specifies the local transmit power level, which
reduces the radio cell size and interference between cells,
on a 2.4-GHz, 802.11b/g radio.
or
Specifies the local transmit power level on a 5-GHz,
802.11a radio.
• On the 2.4-GHz radio, you can set CCK and OFDM
power levels. On the 5-GHz radio, these keywords are
not supported.
• For the 802.11b/g radio, the milliwatt argument can be
7, 10, 13, 15, 17, or 20. For the 802.11a radio, the
milliwatt argument can be 4, 7, 10, 13, or 16.
• Use the maximum keyword to specify the maximum
power level. This is the default setting.

Cisco 800 Series Specifications

General

Model	Cisco 800 Series
Category	Network Router
VPN Support	Yes
Firewall	Yes
Dimensions	Varies by model
Processor	Varies by model
Memory	Varies by model
Operating System	Cisco IOS
WAN Ports	Varies by model
LAN Ports	Varies by model
WAN Interfaces	Varies by model
LAN Interfaces	Fast Ethernet or Gigabit Ethernet