Cisco 800 Series Configuring

Configuring Radio Settings on an Access Point
Configuration Examples for Radio Settings on an Access Point
27
DETAILED STEPS
Configuration Examples for Radio Settings on an Access Point
This section contains the following examples:
• Configuring Radio Data Rates: Example
Configuring Radio Data Rates: Example
The following example shows how to disable the 1-Mbps data rate and set the rest of the data rates to
basic:
configure terminal
interface dot11radio 0
no speed basic-2.0 basic-5.5 basic-11.0
end
copy running-config startup-config
Command or Action Purpose
Step 1
enable
Example:
Router> enable
Enables privileged EXEC mode.
• Enter your password if prompted.
Step 2
configure terminal
Example:
Router# configure terminal
Enters global configuration mode.
Step 3
dot11 phone
Example:
Router(config)# dot11 phone
Enables IEEE 802.11 compliance phone support.
Step 4
end
Example:
Router(config-if)# end
Returns to privileged EXEC mode.
Step 5
copy running-config startup-config
Example:
Router# copy running-config startup-config
(Optional) Saves your entries in the configuration file.

Cisco 800 Series Specifications

General

Model	Cisco 800 Series
Category	Network Router
VPN Support	Yes
Firewall	Yes
Dimensions	Varies by model
Processor	Varies by model
Memory	Varies by model
Operating System	Cisco IOS
WAN Ports	Varies by model
LAN Ports	Varies by model
WAN Interfaces	Varies by model
LAN Interfaces	Fast Ethernet or Gigabit Ethernet