Cisco 800 Series User Manual

3
Complete the information below, and keep it for reference.
2 Overview
This document describes the basic process of cabling and configuring the Internet access device, the Cisco 800 series router. For
advanced cabling information, refer to the Cisco 800 Series Router Hardware Installation Guide. For advanced configuration
information, refer to the Cisco 800 Series Router Software Configuration Guide. These documents are available on Cisco.com.
3 Parts List
The shipment of your Cisco 800 series router includes the following items:
• One Cisco 800 series router
• One yellow Ethernet cable
• One orange ISDN S/T cable (Cisco 801 and Cisco 803 only)
• One red ISDN U cable (Cisco 802 and Cisco 804 only)
• One RJ-45-to-RJ-11 adapter cable (for use with the red ISDN U cable)
• One blue console cable
• One DB-9-to-RJ-45 adapter (for use with the blue console cable)
• One DB-25-to-RJ-45 adapter (for use with the blue console cable)
• One black power supply
• One black power supply cord
• Product Documentation
4 Verify the PC Setup
Before you begin, verify that each computer that will be connected to the router has a network interface card (NIC) installed
and that Transmission Control Protocol/Internet Protocol (TCP/IP) has been loaded and configured. For more information on
how to configure TCP/IP, refer to the PC Configuration Instructions to Establish Cisco Router-to-PC Communications, which
is available on Cisco.com.
Company product purchased from
Company telephone number
Product model number
Product serial number
Maintenance contract number

Cisco 800 Series Specifications

General

Model	Cisco 800 Series
Category	Network Router
VPN Support	Yes
Firewall	Yes
Dimensions	Varies by model
Processor	Varies by model
Memory	Varies by model
Operating System	Cisco IOS
WAN Ports	Varies by model
LAN Ports	Varies by model
WAN Interfaces	Varies by model
LAN Interfaces	Fast Ethernet or Gigabit Ethernet