Cisco 867VAE-W User Manual

18 19
4. Select Connection. Edit the
description to, say “iiNet NBN”.
Make sure Enable PPPoE is
unticked.
5. Select IPv4 address. For Type please
choose DHCP IP and tick Enable NAT.
Click OK to finish. You’ll find WiFi setup
advice on the next page.
2. An Alert prompt will pop up.
Select Yes to continue.
3. Select Primary Secondary
Interface. Primary WAN
Interface should be ticked.

Cisco 867VAE-W Specifications

General

Brand	Cisco
Model	867VAE-W
Category	Network Router
Language	English