2-2 Installation 4038501 Rev C
Tools and Accessories
Required Tools and Hardware
Before you start the installation, make sure you have the following tools and
equipment to connect and configure the amplifier.
Tighten the screws on the lid
3 mm flat-tip screwdriver
Clamp the inner conductor and PE conductor
Connect Protective Earth (PE) to the PE terminal
Torque Specifications
The following table provides the torque specifications.
Tighten from 6.5 Nm to 7 Nm (58 in-lb to 62 in-lb)
RF input/output port
connector
Tighten from 5 Nm to 6 Nm (44 in-lb to 53 in-lb)
Tighten from 2 Nm to 2.5 Nm (18 in-lb to 22 in-lb)
To Next Page
Loading...