Cisco A93280 - Chapter 3 Operation; Overview

4038501 Rev C Operation 3-1
Chapter 3
Operation
Overview
Introduction
This section describes the procedures for setting up and operating the amplifier.
The amplifier can be set up using a computer with an LCI software kit, or a
handheld terminal.
WARNING:
This product should be operated by qualified personnel only. Non-authorized
personnel are not allowed in the site area, otherwise physical injury or
equipment damage may occur.
In This Chapter
This chapter contains the following topics.
Topic
See Page
Starting Up the Amplifier
3-2
Setting Up the Amplifier with a Computer
3-3
Setting Up the Amplifier with a Handheld Terminal
3-8
ROSA Element Management System
3-13
Setting Up Transponders
3-14
Starting Up the Amplifier with the AGC Module
3-16
Setting Up the AGC Module
3-17
Functions of the AGC Module
3-18
Temperature Back-off
3-20