EasyManua.ls Logo

Cisco ANT-4G-OMNI-OUT-N - Outdoor Installations

Cisco ANT-4G-OMNI-OUT-N
535 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
183
Cisco Aironet Dual-Band MIMO Wall-Mounted Omnidirectional Antenna (AIR-ANT2544V4M-R)
Figure 5 Azimuth and Elevation Adjustment
Outdoor Installations
You can mount this antenna outdoors. If you mount the antenna outdoors, you must ensure that the antenna cables exit from
the bottom to prevent any water intrusion and to provide a drain for any moisture that may accumulate inside the antenna.
Mounting on a Ceiling
To mount the antenna on a ceiling, follow these steps:
1. Drill a hole in the ceiling approximately 1.25 in. in diameter.
2. Fit the rubber gasket onto the bottom of the antenna.
3. Insert the antenna shaft through the hole in the ceiling.
4. Thread the jam nut onto the antenna shaft and tighten.
Figure 6 shows the ceiling mount process.

Table of Contents

Other manuals for Cisco ANT-4G-OMNI-OUT-N

Related product manuals