Cisco ASA 5506W-X

Lock slot
The slot accepts a standard Kensington
T-bar locking mechanism for securing
the ASA.
8Reset button
A small recessed button that if pressed
for longer than three seconds resets the
ASA to its default “as-shipped” state
following the next reboot. Configuration
variables are reset to factory default.
However, the flash is not erased and no
files are removed.
You can use the service
sw-reset-button to disable the
reset button. The default is
enabled.
Note
Pressing the reset button on the
ASA 5506W-X does not affect
the AP configuration, but it
causes any unsaved AP
configuration to be lost,
because the system has
rebooted. After the system
reboots, if you want a default
AP configuration, use the
hw-module module wlan
recover configuration
command to recover the AP
configuration.
Note
7
The following figure shows the rear panel of the 5506H-X.
Figure 6: ASA 5506H-X Rear Panel
Cisco ASA 5506-X, ASA 5506W-X, and ASA 5506H-X Hardware Installation Guide
Online Only 7
Overview
Rear Panel