17-10
Cisco ASA Series Firewall CLI Configuration Guide
Chapter 17 Quality of Service
Monitor QoS
conformed 198785 bps, exceed 2303 bps
QoS Priority Statistics
To view statistics for service policies implementing the priority command, use the show service-policy
priority command.
hostname# show service-policy priority
Global policy:
Service-policy: global_fw_policy
Interface outside:
Service-policy: qos
Class-map: TG1-voice
Priority:
Interface outside: aggregate drop 0, aggregate transmit 9383
“Aggregate drop” denotes the aggregated drop in this interface; “aggregate transmit” denotes the
aggregated number of transmitted packets in this interface.
QoS Priority Queue Statistics
To display the priority-queue statistics for an interface, use the show priority-queue statistics
command. The results show the statistics for both the best-effort (BE) queue and the low-latency queue
(LLQ). The following example shows the use of the show priority-queue statistics command for the
interface named test.
hostname# show priority-queue statistics test
Priority-Queue Statistics interface test
Queue Type = BE
Packets Dropped = 0
Packets Transmit = 0
Packets Enqueued = 0
Current Q Length = 0
Max Q Length = 0
Queue Type = LLQ
Packets Dropped = 0
Packets Transmit = 0
Packets Enqueued = 0
Current Q Length = 0
Max Q Length = 0
hostname#
In this statistical report:
• “Packets Dropped” denotes the overall number of packets that have been dropped in this queue.
• “Packets Transmit” denotes the overall number of packets that have been transmitted in this queue.
• “Packets Enqueued” denotes the overall number of packets that have been queued in this queue.
• “Current Q Length” denotes the current depth of this queue.
• “Max Q Length” denotes the maximum depth that ever occurred in this queue.
To Next Page
Loading...
Need help?
General
