Cisco ASA 5540

Chapter 8 Scenario: DMZ Configuration
Configuring the Adaptive Security Appliance for a DMZ Deployment
8-12
Cisco ASA 5500 Series Getting Started Guide
78-19186-01
Step 4 From the Type drop-down list, choose Static.
Step 5 In the Translated Addr. field, enter the IP address of the internal client or network,
or click ..., and choose an the address from the Browse Translated Addr dialog
box. In the IP Address field, enter In this scenario, the IP address of the network
is 192.168.1.0.
Step 6 Click Advanced, and configure the following options in the Advanced NAT
Settings dialog box.
• In the Source Interface drop-down list, choose the Inside interface.
• In the Destination Interface drop-down list, choose the DMZ interface.
These two settings specify the real and/or mapped interfaces where this NAT
rule should apply.