Cisco ASA 5580 - Page 16

Contents
xvi
Cisco ASA 5500 Series Configuration Guide using ASDM
OL-20339-01
Limitations on Configuring a Default Static Route 19-7
Configuring IPv6 Default and Static Routes 19-8
Monitoring a Static or Default Route 19-8
Configuration Examples for Static or Default Routes 19-9
Feature History for Static and Default Routes 19-9
CHAPTER 20 Defining Route Maps 20-1
Route Maps Overview 20-1
Permit and Deny Clauses 20-2
Match and Set Clause Values 20-2
Licensing Requirements for Route Maps 20-3
Guidelines and Limitations 20-3
Defining a Route Map 20-4
Add/Edit a Route Map 20-4
Customizing a Route Map 20-5
Defining a Route to Match a Specific Destination Address 20-5
Configuring the Metric Values for a Route Action 20-6
Configuration Example for Route Maps 20-7
Feature History for Route Maps 20-7
CHAPTER 21 Configuring OSPF 21-1
Information About OSPF 21-1
Licensing Requirements for OSPF 21-3
Guidelines and Limitations 21-3
Configuring OSPF 21-3
Customizing OSPF 21-4
Redistributing Routes Into OSPF 21-5
Configuring Route Summarization When Redistributing Routes into OSPF 21-7
Add a Route Summary Address 21-7
Add/Edit OSPF Summary Address 21-8
Configuring Route Summarization Between OSPF Areas 21-8
Configuring OSPF Interface Parameters 21-9
Configuring OSPF Area Parameters 21-12
Configuring OSPF NSSA 21-13
Defining Static OSPF Neighbors 21-14
Configuring Route Calculation Timers 21-15
Logging Neighbors Going Up or Down 21-16
Configuring Filtering in OSPF 21-16