Cisco ASA 5580

7-4
Cisco ASA 5500 Series Configuration Guide using ASDM
OL-20339-01
Chapter 7 Using the Startup Wizard
Startup Wizard Screens for the ASA 5505 Adaptive Security Appliance
Step 1 - Starting Point or Welcome
Step 1 To change the existing configuration, click the Modify existing configuration radio button.
Step 2 To set the configuration at the factory default values for the inside interface, click the Reset
configuration to factory defaults radio button.
Step 3 To configure the IP address and subnet mask of the management interface, check the Configure the IP
address of the management interface check box.
Step 4 Specify the IP address of the management interface.
Step 5 Choose the subnet mask of the management interface from the drop-down list.
Table 7-2 Startup Wizard Screens for the ASA 5505 Adaptive Security Appliance
Screen Name and Sequence Availability
Step 1 - Starting Point or Welcome, page 7-4 All modes. The Teleworker option in Step 2
- Basic Configuration is available only on
the ASA 5505.
Step 2 - Basic Configuration, page 7-5
Step 3 - Time Zone and Clock Configuration, page 7-5 All modes.
Step 4 - Auto Update Server, page 7-6 Single, routed, and transparent modes.
Enabled only if configured for teleworker
usage.
Step 5 - Management IP Address Configuration,
page 7-6
Single, transparent mode only.
Step 6 - Interface Selection, page 7-6 Single, routed mode only.
Step 7 - Switch Port Allocation, page 7-7
Step 8 - Interface IP Address Configuration, page 7-8
Step 9 - Internet Interface Configuration - PPPoE,
page 7-8
Step 10 - Business Interface Configuration - PPPoE,
page 7-9
Step 11 - Home Interface Configuration - PPPoE,
page 7-10
Step 12 - General Interface Configuration, page 7-10
Step 13 - Static Routes, page 7-11 All modes. Enabled only if configured for
teleworker usage.
Step 14 - DHCP Server, page 7-11 All modes.
Step 15 - Address Translation (NAT/PAT), page 7-12 Single, routed mode only.
Step 16 - Administrative Access, page 7-13 All modes.
Step 17 - Easy VPN Remote Configuration, page 7-14 Single, routed mode, only when enabled for
teleworker usage.
Step 18 - Startup Wizard Summary, page 7-16 All modes.