27-5
Cisco ASA 5500 Series Configuration Guide using ASDM
OL-20339-01
Chapter 27 Configuring Network Object NAT
Configuring Network Object NAT
Figure 27-3 Enabling NAT
Step 6
In the Translated Addr field, click the browse button and choose an existing network object from the
Browse Translated Addr dialog box.
Note The object or group cannot contain a subnet.
You can share this mapped object across different dynamic NAT rules, if desired.
Figure 27-4 Browse Dialog Box
See the “Guidelines and Limitations” section on page 27-2 for information about disallowed mapped IP
addresses.
You can also create a new named object from the Browse Translated Addr dialog box and use this object
as the mapped address:
a. Add the new network object.
Figure 27-5 Adding a New Network Object for the NAT Pool
To Next Page
Loading...
