Cisco ASA 5585-X User Manual

Cisco ASA 5585-X Quick Start Guide
3. Network Considerations for Multiple SSPs
2
2. Connect the power cables to the electrical outlets.
3. Power on the ASA. If you have redundant power supplies, you must power on both modules.
4. Check the Power LED on the front of the ASA; the AC ON indicator should be green, the FAN ON indicator
should be green, and the OUT OK indicator should be off.
3. Network Considerations for Multiple SSPs
The ASA SSP resides in slot 0 (bottom). A second SSP (or network module) can be installed in slot 1 (top). When
you install a non-ASA SSP in slot 1, all non-management interfaces belong to the ASA in slot 0, while the
management interfaces belong to the module. If you install dual ASA SSPs, then they are completely independent
systems.
Default Configuration for Management
See the following table for default configurations for the Management interfaces depending on which module is
installed in slot 1. Note that the left-hand Management interface (when facing the back of the chassis) is not
configured by default.
1
Power Supply Module (PS0)
2
Power Supply Module (PS1)
249822
Cisco ASA 1200W AC
100-240V
15.0/8.0.A
56/60Hz
IN
OK
FAN
OK
OUT
FAIL
Cisco ASA 1200W AC
100-240V
15.0/8.0.A
56/60Hz
IN
OK
FAN
OK
OUT
FAIL
1 2
P
W
R
BO
OT
A
LARM
ACT
V
P
N
P
S
1
H
DD1
P
S
0
H
DD0
USB
RESET
0
SFP1
SFP0
101234567
MGMT
0
1
AUX CONSOLE
P
W
R
BO
O
T
A
LAR
M
ACT
V
P
N
P
S
1
HDD1
P
S
0
H
D
D
0
USB
RESET
0
SFP1
SFP0
101234567
MGMT
0
1
AUX CONSOLE
ASA Management 0/0
Default IP: 192.168.1.1
Module Management 1/0
Default IP: Varies

Cisco ASA 5585-X Specifications

General

Firewall Throughput	up to 20 Gbps
Maximum VPN Peers	10, 000
IPS Throughput	up to 10 Gbps
Maximum Concurrent Connections	10, 000, 000
Security Contexts	250
Interfaces	8 x 10 Gigabit Ethernet
Connections Per Second	350, 000
Power Supply	Dual, hot-swappable