Cisco ASR-920-24SZ-IM Installing

Procedure
Step 1 Connect a USB Type A-to-Type A cable to the USB console port, as shown in figure. If you are using the
USB serial port for the first time on a Windows-based PC, install the USB driver now according to the
instructions in the following sections:
• Installing the Cisco USB Device Driver
• Uninstalling the Cisco USB Device Driver
You cannot use the USB port and the EIA port concurrently. When the USB port is used, it takes
priority over the EIA port.
Note
Step 2 Connect the USB Type A cable to the PC.
Step 3 To communicate with the router, start a terminal emulator application, such as Microsoft Windows
HyperTerminal. Configure the software with the following parameters:
• 9600 baud
• 8 data bits
• no parity
• 1 stop-bit
• no flow control
Figure 37: Connecting the USB Console Cable to the Cisco ASR 920 Router
CableLabelCableLabel
USB USB Type-A
to USB Type-A
console cable
2USB Type-A console port1
Installing the Router
45
Installing the Router
Connecting to the USB Serial Port Using Microsoft Windows

Cisco ASR-920-24SZ-IM Specifications

General

Brand	Cisco
Model	ASR-920-24SZ-IM
Category	Network Router
Language	English