Cisco ASR-920-24SZ-IM User Manual

SUMMARY STEPS
1.
When your system is booting, type No at the prompt.
2.
Press Return to enter the user EXEC mode.
3.
From the user EXEC mode, enter the enable command, as shown in the following example:
4.
At the password prompt, enter your system password, as shown in the following example. If an enable
password has not been set on your system, you can skip this step.
5.
To exit the console session, enter the quit command, as shown in the following example:
DETAILED STEPS
Step 1
When your system is booting, type No at the prompt.
Example:
--- System Configuration Dialog ---
Would you like to enter the initial configuration dialog? [yes/no]: no
Step 2
Press Return to enter the user EXEC mode.
The following prompt is displayed:
Example:
Router>
Step 3
From the user EXEC mode, enter the enable command, as shown in the following example:
Example:
Router> enable
Step 4
At the password prompt, enter your system password, as shown in the following example. If an enable password has not
been set on your system, you can skip this step.
Example:
Password: enablepass
When your password is accepted, the privileged EXEC mode prompt is displayed:
Example:
Router#
You now have access to the CLI in the privileged EXEC mode. You can enter the necessary commands to complete the
required tasks.
Step 5
To exit the console session, enter the quit command, as shown in the following example:
Example:
Router# quit
Cisco ASR-920-24SZ-IM, ASR-920-24SZ-M, ASR-920-24TZ-M Aggregation Services Router Hardware Installation
Guide
123
Initial Configuration
Accessing the CLI Using the Console

Cisco ASR-920-24SZ-IM Specifications

General

Brand	Cisco
Model	ASR-920-24SZ-IM
Category	Network Router
Language	English