To Next PageTo Next Page
Need help?Do you have a question about the Cisco C9300L-24P-4X and is the answer not in the manual?
General| Model | C9300L-24P-4X |
|---|---|
| Device Type | Switch |
| Form Factor | Rack-mountable |
| Enclosure Type | 1U |
| Subtype | Gigabit Ethernet |
| Power Over Ethernet (PoE) | Yes |
| PoE Budget | 370W |
| Switching Capacity | 128 Gbps |
| Forwarding Rate | 95.23 Mpps |
| RAM | 4 GB |
| Flash Memory | 16 GB |
| Power Device | Internal power supply |
| Installed Qty | 1 |
| Power Redundancy | Optional |
| Width | 17.5 in |
| Operating System | Cisco IOS XE |
| Ports | 24 x 10/100/1000 PoE+ ports, 4 x 10 Gigabit SFP+ uplinks |
| MAC Address Table Size | 32000 entries |
| Routing Protocol | OSPF, BGP, EIGRP, RIP |
| Remote Management Protocol | SNMP, SSH, Telnet |
| Features | VLAN support, DHCP snooping, IPv6 support, Quality of Service (QoS) |
| Compliant Standards | IEEE 802.1Q, IEEE 802.1x, IEEE 802.3, IEEE 802.3ab, IEEE 802.3af, IEEE 802.3at, IEEE 802.3az, IEEE 802.3u, IEEE 802.3x, IEEE 802.3z |
| Memory | 4 GB RAM |
| Operating Temperature | 32 to 104 °F |
| Operating Humidity | 10% to 90% (non-condensing) |
| Stacking | Up to 8 switches |
Crucial safety warnings and precautions to be followed during installation.
Guidelines to follow for proper installation of the switch.
Essential site requirements for successful switch installation and operation.
Procedures for properly grounding the switch.
Precautions and procedures to prevent Electrostatic Discharge (ESD) damage.
Steps to verify the switch's operational status after installation.
Guidelines for connecting switches for data and power stacking.
Instructions for mounting the switch into a rack.
Detailed steps for installing a network module into the switch.
Step-by-step instructions for installing or replacing AC power supplies.
Instructions for installing a DC power supply.
Procedures for properly grounding the switch.
Detailed steps for installing a fan module into the switch.
