Cisco Catalyst 2960 Series Datasheet

Data Sheet
© 2009 Cisco Systems, Inc. All rights reserved. This document is Cisco Public Information. Page 17 of 21
5% Throughput Switch Power consumption (with 50% PoE loads).
The numbers indicate the power consumed by a typical system (the switch and the corresponding
PoE loads) under normal conditions. Normal conditions signify a temperature of 25 Degrees
Celsius, atmospheric pressure in the range of 860 to 1060 mbar and relative Humidity between 30
to 75%. The numbers below indicate a 5% traffic load and 50% PoE load on the switch and its
uplinks.
Table 6. Management and Standards Support for Cisco Catalyst 2960 LAN Base Switches
Description Specification
Management
●
BRIDGE-MIB
●
CISCO-CABLE-DIAG-MIB
●
CISCO-CDP-MIB
●
CISCO-CLUSTER-MIB
●
CISCO-CONFIG-COPY-MIB
●
CISCO-CONFIG-MAN-MIB
●
CISCO-DHCP-SNOOPING-MIB
●
CISCO-ENTITY-VENDORTYPE-OID-MIB
●
CISCO-ENVMON-MIB
●
CISCO-ERR-DISABLE-MIB
●
CISCO-FLASH-MIB
●
CISCO-FTP-CLIENT-MIB
●
CISCO-IGMP-FILTER-MIB
●
CISCO-IMAGE-MIB
●
CISCO-IP-STAT-MIB
●
CISCO-LAG-MIB
●
CISCO-MAC-NOTIFICATION-MIB
●
CISCO-MEMORY-POOL-MIB
●
CISCO-PAGP-MIB
●
CISCO-PING-MIB
●
CISCO-POE-EXTENSIONS-MIB
●
CISCO-PORT-QOS-MIB
●
CISCO-PORT-SECURITY-MIB
●
CISCO-PORT-STORM-CONTROL-MIB
●
CISCO-PRODUCTS-MIB
●
CISCO-PROCESS-MIB
●
CISCO-RTTMON-MIB
●
CISCO-SMI-MIB
●
CISCO-STP-EXTENSIONS-MIB
●
CISCO-SYSLOG-MIB
●
CISCO-TC-MIB
●
CICSO-TCP-MIB
●
CISCO-UDLDP-MIB
●
CISCO-VLAN-IFTABLE-
RELATIONSHIP-MIB
●
CISCO-VLAN-MEMBERSHIP-MIB
●
CISCO-VTP-MIB
●
ENTITY-MIB
●
ETHERLIKE-MIB
●
IEEE8021-PAE-MIB
●
IEEE8023-LAG-MIB
●
IF-MIB
●
INET-ADDRESS-MIB
●
OLD-CISCO-CHASSIS-MIB
●
OLD-CISCO-FLASH-MIB
●
OLD-CISCO-INTERFACES-MIB
●
OLD-CISCO-IP-MIB
●
OLD-CISCO-SYS-MIB
●
OLD-CISCO-TCP-MIB
●
OLD-CISCO-TS-MIB
●
RFC1213-MIB
●
RMON-MIB
●
RMON2-MIB
●
SNMP-FRAMEWORK-MIB
●
SNMP-MPD-MIB
●
SNMP-NOTIFICATION-MIB
●
SNMP-TARGET-MIB
●
SNMPv2-MIB
●
TCP-MIB
●
UDP-MIB
Standards
●
IEEE 802.1D Spanning Tree Protocol
●
IEEE 802.1p CoS Prioritization
●
IEEE 802.1Q VLAN
●
IEEE 802.1s
●
IEEE 802.1w
●
IEEE 802.1x
●
IEEE 802.1AB (LLDP)
●
IEEE 802.3ad
●
IEEE 802.3af
●
IEEE 802.3ah (100BASE-X single/multimode
fiber only)
●
IEEE 802.3x full duplex on 10BASE-T,
100BASE-TX, and 1000BASE-T ports
●
IEEE 802.3 10BASE-T specification
●
IEEE 802.3u 100BASE-TX specification
●
IEEE 802.3ab 1000BASE-T specification
●
IEEE 802.3z 1000BASE-X specification
●
100BASE-BX (SFP)
●
100BASE-FX (SFP)
●
100BASE-LX (SFP)
●
1000BASE-BX (SFP)
●
1000BASE-SX (SFP)
●
1000BASE-LX/LH (SFP)
●
1000BASE-ZX (SFP)
●
1000BASE-CWDM SFP 1470 nm
●
1000BASE-CWDM SFP 1490 nm
●
1000BASE-CWDM SFP 1510 nm
●
1000BASE-CWDM SFP 1530 nm
●
1000BASE-CWDM SFP 1550 nm
●
1000BASE-CWDM SFP 1570 nm
●
1000BASE-CWDM SFP 1590 nm
●
1000BASE-CWDM SFP 1610 nm
●
RMON I and II standards
●
SNMPv1, SNMPv2c, and SNMPv3

Cisco Catalyst 2960 Series Specifications

General

Layer	Layer 2
Power over Ethernet (PoE)	Available on some models
RAM	128 MB
Flash Memory	32 MB
MAC Address Table Size	8000
Operating Temperature	0°C to 45°C (32 to 113°F)
Ports	24 or 48 x 10/100/1000